Front page
Next reviews

SilverStone FG1x1 LED Fan Grill

Mi True Wireless Earbuds

Roccat Kone AIMO Remastered Mouse

Amazfit Stratos 3 Fitness Watch

SilverStone AB120i-ARGB Fan Kit

Jabra Elite 85h Headset

YI Dome X Camera

Roccat Vulcan 120 AIMO Keyboard

Riotoro CR100TG Casing

Mi Roborock S5 Max Vacuum Robot

SilverStone CPL02-E+LS04 ARGB Light

2019-01-01 15:00Danish version

3D Print Link collection

Ender 3 Upgrades and guides
Information about 3D printing and fumes from materials:
Creality 3D Official Store (AliExpress):
Danish 3D Shops:



Endcaps/Cable guides:

Filament guides:


Extruder knob:


Cabel Clips:



Tool Accesories:

Fan ducts for print head:

Vent Ring:


Jack for level middle bed:
Damper feet:
Damper feet:
Guick Release lock:
Filament cleaner:
Belt tension:

Stepper damper mounting (without removing pulley)

Z Axel:

3D Modeling:

Fusion 360 (Free):


Simplify 3D (Paid):
Cura (Free):

FFF Profiles:

Filament Frenzy:



Heat tower: (190-240 degrees)

Choose the temperature that has the nicest print, and not least the nicest lines in the bridge.

The profile in the slicer is made with several processes. You place the blocks on top of each other and make a process for each block with the temperature on the block. Start with the hottest and end with the coldest. Be ready to pause the printer if it starts to peck at the extruder at low temperatures. As you can see, the top block here is not very nice.

Retraction tower:

Choose the height that looks the nicest.

The profile you make in your slicer should raise the retraction every 0.5 cm, by 2 mm (By bowden tube printer).

So the image shown shows a fine retraction from 1 centimeter, so the retraction will be 4 mm on this red filament.

Extrusion width:

This square is printed with an extrusion multiplier of 1 and an extrusion width of 0.48mm (auto).

The profile settings in the slicer must be 1 perimeter, 1 bottom layer, 0 top layer.

So when the square is printed, one should be able to measure the wall thickness to 0.48mm.

It's a little tricky and you can skip this test.


E-Step calibration:

The cube should measure 20 x 20mm when printed. This way you can also see if the goals hold or whether further adjustments need to be made.





Strengthening print:

Here is a link on how to strengthening the print. This can typically be done in an oven where you heat up the print to change the structure of the print and remove tension from the print itself.



HwT: Astro A50 Wireless headset

HwT: Asus ROG STRIX GO 2.4 Headset

HwT: Endgame Gear XMOne Mouse

HwT: Logitech G604 Lightspeed

HwT: Roccat Vulcan 121 AIMO

HwT: Rocat Kain 120 AIMO Mouse

HwT: Havit Gamenote HV-KB395L

Tweak: DeepCool Assassin III Cooler

HwT: COUGAR Attila In-Ear Headset

HwT: Corsair Nightsword RGB Mouse